LifeSize Room - Display Output Setup; Configuring Display Output from Phone

30 LifeSize Room User Guide
To resolve problems with VGA monitors from the LifeSize Room interface, follow these
steps:
1. Ensure there are no calls in progress.
2. Select the button from the main screen to access the System menu.
3. Select the Administrator Preferences button.
4. Enter the administrator password and press OK.
5. Select the Displays button and press OK.
6. Select VGA for the Display Type preference for the display you wish to manually
configure.
If your display supports both 1280x720 and 1280x768, you can manually configure the
system to use one of these resolutions by setting the VGA Resolution preference for the
display you wish to manually configure.
Configuring Display Output from LifeSize Phone
If you have not completed the initial configuration for LifeSize Room, or the attached display
is blank, you must configure your display from the administrator interface on the LifeSize
Phone.
To resolve problems with VGA monitors from the LifeSize Phone interface, follow these
steps:
1. Ensure there are no calls in progress.
2. Log in to the Admin Menu on your LifeSize Phone.
a. Press sequentially when the phone is idle.
b. Enter the default administrator password (1 2 3 4 by default) and press .
3. Press 1 on the keypad to select Preferences.
4. Press 1 or 2 to select the display you wish to configure.
1 - Display 1
2 - Display 2
5. Select VGA for the Display Type to manually set the display to VGA.
If your display supports both 1280x720 and 1280x768, you can manually configure the
system to use one of these resolutions by setting the VGA Resolution preference.