LifeSource Health Line (Toll-Free): 1-888-726-9966
E-11
ABOUT MEMORY
The UA-705 automatically stores up to 30 blood pressure and pulse measure-
ments in its memory. Measurements stored in memory are assigned an index
number in the order of the newest to the oldest. The oldest reading displays
as "n01".
To retrieve readings, follow these simple steps:
1. When the display screen is blank, press and hold the
START button. While holding down the START button,
you will see the average reading displayed first. You will
then see the memory index number (e.g. n04) of the most
recent reading followed by the measurement. Release the
START button when you see the memory index number.
2. The display will shut off automatically a few seconds after
all of the readings are displayed. To turn off the monitor at
any time, press the START button.
To clear the measurement history from memory, remove the
battery from the unit and then place the battery back into the
battery holder.
NOTE: If there are no measurements stored in memory, you will see two 0s
displayed vertically followed by a blinking "A00".
NOTE: Stored measurements will be lost if batteries become low or are
removed.
UA705 6/3/05 12:47 PM Page 15
To Next Page
Loading...
Need help?
General
