5. Some treadmill motors may use a push clip
instead. In this case, gently push the clip down and
then up to release it from its latch.
6. Remove the clip, noting the direction in which it
was originally placed, and put it safely aside.
7. Slide the motor brush out from its slot. If the brush
is shorter than 2cm on the longest side, you will need
8. Slide the motor brush lead off the terminal using a
small screwdriver or needle-nosed pliers.
9. Slide the motor brush out from its slot. If the brush
is shorter than 2cm on the longest side, you will need
10. Slide the motor brush out from its slot. If the
brush is shorter than 2cm on the longest side, you
will need to replace both brushes.
To Next Page
Loading...
