9
9
Required For This Page:
1/2” Wrenches
Snap the Slide Collar (CC) onto the Bottom Pole.
The head of the Tap Bolt (BB) ts into the hex-shaped hole in one
of the Locking Knobs (CG).
BB
CG
CL
CL
CG
BC
BP
CC
Make sure the pole is
vertical before completely
tightening all Base and
Pole Brace hardware.
Tip the system forward
so the pole is resting on
the ground. DO NOT
stand the system up until
it is lled with weight
later in the instructions.
BB
BC
HD9129
(1)
(1)
BA
AE
8
HD9102B
BD
(2)
(4)
(2)
AE
CL
BA
BD
BD
The straight end of the Pole Brace (CL)
attaches to the Base (CI). The angled
end attaches to the pole. Complete for
both sides of the Base.
Only nger tighten
the Nuts now.
CL
AF
CI
To Next Page
Loading...
