Lifetime 60066 - Step 2.12: Set Latch Assemblies

TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
25
SEC
ADW
ADW
SEC
2.12
3ETTWOLatch Assemblies (BJA)INTHELOCATIONSSHOWNANDALIGNTHEHOLESINTHE,ATCHESWITHTHEDIVOTSINTHE
0ANEL$RILLONEvHOLEINTOTHEHOLEINEACH,ATCHANDTHROUGHTHEPLASTIC)NSERTAXv0HILLIPS0AN
Head Screw (ADW)INTOTHEHOLEOFEACH,ATCHUNTILTHEHEADOFTHE3CREWISmUSHWITHTHE,ATCHIt’s OK if the Screws
(ADW) spin freely at this point. Do not worry about stripping the plastic. &INALLYONTHEINSIDEOFTHE4UMBLERSECURETHE
3CREWSWITHTWOPlastic Nuts (BHK). Tighten the Screws (ADW) into the Plastic Nuts (BHK) with a screwdriver only. Do not
overtighten.
BHKX
ADWX
2
BJAX
BJA
BJA
ARAX