Lifetime 60066 - Step 2.13: Set Pinned Hinges

TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
26
SEC
SEC
2.13
/NTHEOTHERSIDEOFTHE4UMBLERSETTWOPinned Hinges (BIY)INTHELOCATIONSSHOWNANDALIGNTHEHOLESINTHE
0INNED(INGESWITHTHEDIVOTSINTHE0ANEL$RILLTWOvHOLESINTOTHEHOLESINEACH0INNED(INGEAND
THROUGHTHEPLASTIC)NSERTTWOXv0HILLIPS0AN(EAD3CREWS!$7INTOTHEHOLESOFEACH0INNED(INGEUNTIL
THEHEADSOFTHE3CREWSAREmUSHWITHTHE0INNED(INGESIt’s OK if the Screws (ADW) spin freely at this point. Do not
worry about stripping the plastic. &INALLYONTHEINSIDEOFTHE4UMBLERSECURETHE3CREWSWITHFOURPlastic Nuts
(BHK). Tighten the Screws (ADW) into the Plastic Nuts (BHK) with a screwdriver only. Do not overtighten.
BHKX
ADWX
2
BIYX
ADW
BIY
BIY
ADW
ARAX