Lifetime 6418 - Page 24

24
11.3: Attach the Rear Wall Support (AD) to the Gable assembly using
six (6) 1/4” x 1 1/8” Pan-head Screws (GA) and one (1) #10 x 1 1/4”
Pan-head Screw (GC).
11.4: Insert the two (2) End Plugs (GB) into the ends of the Rear Wall
Support. Set aside assembly until later.
Hardware Bags:
1020803
3/8” Wrench (1)
Drill/Screwdriver
GC (1)
GA (6)
GA
GA
AD
GC
GB
GB
GA
AD
GC