Lifetime 6426 - BEFORE BEGINNING ASSEMBLY

5
*See “Screwdriver Notice” on page 7.
TOOLS REQUIRED FOR THIS ASSEMBLY
*Two adults required to
complete assembly*
(+ one adult suggested as an instruction reader)
Only adults should set up the product. Do not allow children
in the set-up area until assembly is complete.
BEFORE BEGINNING ASSEMBLY
Keep the hardware bags and their contents separate. If any parts are missing, call our
Customer Service Department.
2EADTHEh#ONGRATULATIONSvLETTERONPAGEIdentify and inventory all parts and hardware
using the parts and hardware lists and identifi ers in this document.

*Phillips Screwdriver *Electric Drill 7/16" Wrench 3/8" Wrench Safety Glasses
(x1) (x1) X (x1)
(1 pair for each
person)
1. Check contents of boxes and compare to parts listed on the Parts List.
&OLLOWINSTRUCTIONSTHATCAMEWITHYOURSHEDBUTADDEXTRAmOORPANELWALLPANELS2OOF#APAND3KYLIGHTAT
appropriate points in the assembly.
1. Remove any bolts or screws being used to anchor the shed to the ground.
2EMOVEANYOBJECTSFROMBACKSHELVES
2EMOVEANYSHELVESPEGBOARDORPEGBOARDSTRIPSOROTHEROBJECTSHANGINGONTHELASTTWOSIDE7ALL0ANELSONEITHER
side.
4. Check contents of boxes and compare to parts listed on the Parts List.
5. Follow the steps in this manual.
6. If you are extending an 8’ x 5’ shed you will need to modify the following instructions by not removing as many parts as
shown in the illustrations.
IF YOU ARE INSTALLING A NEW SHED
IF YOU ARE EXTENDING AN EXISTING SHED