EasyManua.ls Logo

Lifetime SPEED SHIFT 90227 - Page 36

Lifetime SPEED SHIFT 90227
48 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
32
TOOLS AND HARDWARE REQUIRED / OUTILS ET QUINCAILLERIE REQUIS / INSTRUMENTAL Y HERRAJE REQUERIDOS
X SECTION 6 (CONTINUED) / SECTION 6 (SUITE) / SECCIÓN 6 (CONTINUACIÓN)
AEF
6.2B
Two adults are required to complete assembly. To prevent serious injuries, the Pole should be held down by
one adult at all times while the Base is being fi lled.
Il faut deux personnes adultes pour terminer l’assemblage. Pour éviter des accidents graves, le poteau
doit toujours être maintenu par une personne adulte pendant le remplissage de la base.
Dos adultos son requeridos para completar el ensamble. Para evitar lesiones graves, un adulto debe man-
tener horizontal el poste a todos momentos mientras que otro adulto termine de llenar la base.
AEF
• OPTION B: Filling the Base (AJM) with Water. Sand is recommended.
• OPTION B: Remplissez la base (AJM) avec de l’eau. Nous recommandons sable
• OPCIÓN B: Llene la base (AJM) con agua. Se recomienda arena.
1. Insert Cap (AEF) into Base as shown.
2. Add cold water up to the fi ll hole, leaving two inches of space at the top for expansion.
3. Add one tablespoon of chlorine bleach to the water to prevent algae formation.
4. Insert another Cap (AEF) into Base as shown.
5. Using two adults, stand the Base (AJM) up on a smooth surface.
1. Insérez le capuchon (AEF) dans la base comme illustré.
2. Ajoutez de l’eau froide jusqu’au trou de remplissage, en laissant 6 cm d’espace à la partie supérieur pour la
dilatation.
3.Ajoutez une cuillerée de chlore à l’eau pour éviter la formation d’algues.
4. Insérez l’autre capuchon (AEF) dans la base comme illustré.
5. À l’aide d’autre adulte, redressez la base sur une surface lisse.
1. Inserte el tapón (AEF) en la base como se muestra.
2. Añada agua fría hasta el orifi cio de llenado, dejando 6 cm de espacio al tope para la expansión.
3. Añada una cucharada de cloro al agua para evitar la formación de algas.
4. Inserte otro tapón (AEF) en la base como se muestra.
5. Usando otro adulto, ponga la base vertical sobre una superfi cie lisa.

Related product manuals