REGULATORY & COMPLIANCE INFORMATION
Specifications
To see a full list of LIFX® product specifications applicable to this Product,
go to www.lifx.com/compliance
Certification
LIFX® adheres to the certification requirements for various regions around
the world. To see a full list of LIFX® certifications please go to www.lifx.com/
compliance to ensure LIFX® complies with the certification requirements in
your region.
RF EXPOSURE WARNING
This equipment must be installed and operated in accordance with provided
instructions and the antenna(s) used for this transmitter must be installed to
provide a separation distance of at least 20 cm from all persons and must not
be co-located or operating in conjunction with any other antenna or transmitter.
End-users and installers must be provided with antenna installation instructions
and transmitter operating conditions for satisfying RF exposure compliance.
CHANGES & MODIFICATION
Changes or modifications made to this device may void certification of the
device. Changes or modifications made to this unit not expressly approved by
the party responsible for compliance could void the user‘s authority to operate
the equipment.
RECOMMENDED INSTALLATION REQUIREMENTS
The LIFX® Switch should only be installed by a qualified electrician in compliance
with local electrical installation regulations. It is recommended that the LIFX®
Switch be installed away from other devices designed to receive or transmit
radio signals.
INTERFERENCE
LIFX® Switch has been designed to minimise interference with other radio,
broadcast or receiving devices. The manufacturer is not responsible for any
interference caused as a result of modifications to the product or by failure to
adhere to the recommendations in this document and at support.lifx.com. This
device generates radio frequency energy and, if not installed in accordance with
the “recommended installation requirements” may cause harmful interference
to radio communication devices. If the device is causing radio interference it is
recommended that the user try:
a. relocating the device to a dierent place;
b. adjust the antenna on the receiving device;
c. consult a technician experienced in radio interference.
LIFX® Switch is not designed for use in:
• Excessively hot environments (e.g. close to ovens, radiators,
heaters, etc.)
• Regions or countries other than that in which the product was
To Next Page
Loading...
Need help?
General