INSTALLATION INSTRUCTIONS
IMPORTANT SAFETY NOTICES
• The LIFX Switch MUST be installed by a licensed
electrician in accondance with local rules and codes
• Neutral wire required to the Switch
• Electrical power must be cut off before installation/
repair
• Do not overload! Each gang is rated to 250W with a
total load to the switch 1000W
WARNING - RISK OF OVERHEATING OR FIRE IF THESE
LIMITS ARE EXCEEDED.
The LIFX Switch is capable of being mounted using most
standard stud brackets, or mounting boxes.
With the wall mounting box and electrical wiring in place,
the switch can be installed.
• Open the front cover with a small flat head screwdriver.
To Next Page
Loading...