What to do if my LIGHT MY BRICKS Lighting Equipment has a short circuit?
If you suspect a short circuit, which could be caused by bent pins inside the port touching each other, immediately disconnect the power.
What to do if AA batteries are not installed correctly in the AA battery pack of my LIGHT MY BRICKS 21333 Lighting Equipment?
If AA batteries are not installed correctly in the AA battery pack, ensure the flat side of the battery is paired with the spring side of the battery pack.
What to do if CR2032 batteries are not correctly inserted in the stacked battery pack of my LIGHT MY BRICKS 21333?
If CR2032 batteries are not correctly inserted in the stacked battery pack, ensure that both batteries have the ' + ' symbol facing upwards.
What to do if CR2032 batteries are not correctly inserted in the flat battery pack of my LIGHT MY BRICKS Lighting Equipment?
If CR2032 batteries are not correctly inserted in the flat battery pack, check that the ' + ' side of the battery pack has the battery with the ' + ' symbol facing downwards.
How to fix LIGHT MY BRICKS 21333 Lighting Equipment when batteries have no power?
If the batteries have no power, replace the batteries.
General| Brand | LIGHT MY BRICKS |
|---|---|
| Model | 21333 |
| Category | Lighting Equipment |
| Language | English |
Guides on routing cables correctly between and under LEGO bricks to prevent damage.
Instructions for properly connecting cable connectors to expansion boards, noting orientation.
Guidance on connecting cable connectors to LED strip lights and micro expansion board ports.
Proper placement of bit lights under LEGO bricks, ensuring correct orientation of the LED component.
Detailed step-by-step guide for the initial phase of the light kit installation.
Continuation of the step-by-step guide for the latter part of the light kit installation.
General recommendations for preventing damage and resolving common issues with the light kit.
Guide to checking correct battery type, orientation, and installation in various battery packs.
Inspecting wires for damage and checking expansion board ports for bent pins or short circuits.
To Next Page