LEGO VINCENT VAN GOGH - THE STARRY NIGHT 21333 LIGHT KIT INSTALL GUIDE
INSTRUCTIONS 31
Legend
DISCONNECT
CONNECT /
RECONNECT
TURN / FLIP DIRECTIONAL TWIST / BRAID POWER ON TEST NOTE ICON
31
You should have
these parts left over
that were removed
from the LEGO set
Ensure the cables
are going through
the back of the
frame. Press all of the
sides down firmly
Ensure the frame
is properly connected
together
Removed Parts
Connect the other
end to a 5V USB
Power Bank, 5V USB
Wall Adaptor, or USB
to AA Battery Pack
(sold separately)
If you experience any issues with the lights not working and suspect an issue with a component, please try a dierent port on the expansion board to verify where the fault lies (with the light or
expansion board). To correct any issues with expansion board ports, please view the section addressing expansion board issues in our troubleshooting section.
To Next Page