Light4Me SMART BEAM 90 - General Troubleshooting

8
qualified technicians can do the repair work.
In order to maintain the gobo wheel smooth rotation and smooth movement, it
is suggested to add grease for the rotation gobo wheel every two months.
Should use good quality grease.
In order to ensure the fixture working well, maintain the cleanness of fixture is
very necessary. It should be clean once every 30 days after cooling the fans.
Internal and external optical lens, reflector and coating color filter cleaning
must be carried out periodically to optimize the output light efficiency. Do not
use any contains chemical solvent cleaning coating color filter
Cleaning the fixture depending on the operating frequency of fixture and the
surrounding environment. Clean with a soft cloth and cleaning products for
glass, suggest to clean the external optical system at least once every 30
days , clean the internal optical system at least once every 30/60 days.
Please do not use alcohol and other organic solvents to wipe housing, lest
cause damage.
5. General troubleshooting
Phenomenon
Solution
Fixture can not start to work
1. Check if the power fuse burnout
Fixture light normally,
but no responding to
the DMX controller
1. Check if the DMX start address is correct
2. Check if the XLR signal cable was
damaged
Fixture work intermittently
Check if the fan work well, Whether dust
blocked fan and fan nets
Dark light, brightness
decreases obviously
1. Check whether the internal and external
optical system clean
Beam is not pure (have a
halo）
Clean the dust and oil of bulb, lens and other
parts
The beam distortion serious
1. Check whether the lens is broken
2. Clean the dust or oil of lens