DEUTSCH ENGLISH FRANCAIS ESPAÑOL
DEUTSCH
ENGLISH
Troubleshooting:
Warning! (Fault during data transmission)
Never connect the DMX input or output to audio devices such as power
amplifi ers or mixing consoles!
DMX cables enable interference-free operation and the highest possible
transmission reliability of signal data. Do not use microphone cables.
The following overview is intended as an aid to rapid troubleshooting. If you are unsure,
contact the manufacturer, the dealer or appropriate specialist personnel. Never open the
device by yourself!
If the above troubleshooting has not been successful, please contact our service staff.
You can fi nd the contact details at www.musicstore.de.
Cleaning:
Regular cleaning of the device from dirt and dust increases the shelf life of the product.
Always disconnect the unit from the power supply while cleaning it. Optical lenses should
be cleaned with a dry microfi ber cloth. This also optimises the light output. Never clean the
device with water! Ventilation grilles and openings should always be free of dust and dirt.
Compressed air sprays are ideal for this application.
Symptoms Troubleshooting
No Function Check the network connection and its fuse.
No Reaction in DMX Mode
Check the cable connections
If available, try an alternative DMX controller
No Reaction from Remote
Control
Change the battery in your remote control
Make sure that the IR transmitter and receiver are within
a short and clear distance of each other.
To Next Page
Loading...
Need help?
General
