19
DEUTSCH ENGLISH
NOTE! (Power supply)
Make sure that the device voltage matches your local mains voltage. It is
strongly recommended to protect your mains socket with a residual current
circuit breaker (RCD).
Due to the PowerCon input and output, a maximum of 4 Vector Shaft 7R can
be connected to the 1st device and supplied with power.
If you do not use your device for a longer period of time, disconnect the device
from the mains to minimize dangers. The same applies to thunderstorms or
floods, etc.
WARNING! (Mobile device)
Due to its structural characteristics, the device is able to perform fast mo-
vements (inclination and rotation). This applies from the moment the unit is
switched on until it is switched off. Before switching on the device, make sure
that there are no persons directly at the device and that the range of movement
of the device is not restricted in any way.
If work is carried out in the immediate vicinity of the product, the product must
remain switched off!
Installation:
Always check the device for damage before use. Use the original packaging or suitable transport or
storage packaging to protect the product optimally from influences such as dust or moisture, etc.
when not in use.
The device can be installed either standing or hanging. The mounting must always be done on a
solid, approved support or an appropriate surface. Use the opening of the brackets to attach the
device. Always create a second, separate safeguard for the device, e.g. by means of a safety wire.
All work on the device (e.g. installation) should always be carried out from a stable and approved
platform. Make sure that the area below you is closed off.
Please note that the use of this device with a dimmer is not possible!
WARNING! (Risk of injury from falling)
It must be ensured that the device complies with all legal standards and regula-
tions in the respective country of use. Ensure that the device is always secured by
a second mounting cable (e.g. Safety).
NOTE! (Overheating)
The maximum permissible ambient temperature of this device is 40° C. Ensure
that the unit is always adequately ventilated.
To Next Page
Loading...
Need help?
General
