Lightspeed Redcat Access - Overview; System Components and Unpacking

6
1. Overview 2. Daily Operation
3. Optional
Accessories
4. Maintenance &
Troubleshooting
5. Warranty, Safety
& Specifications
SYSTEM COMPONENTS AND UNPACKING
The standard configuration of the Topcat
®
system will contain:
Cradle Charger for
Flexmike
Flexmike
Volume Control
Microphone
Topcat Access
Topcat Access
SECTION 1:
OVERVIEW
1 2
NOTE ON REGISTRATION: The Topcat and any wireless components (microphones, Activate
Station, Media Connector) are pre-registered (paired) together at the Lightspeed factory as
required for proper operation. If paired components are separated and swapped during the
installation process, they must be re-registered. If necessary, please refer to the registration
instructions at www.lightspeed-tek.com/accessregistration.
Lightspeed recommends that the microphone(s), Activate, Media Connector and/or the
accessory box be labeled with the room number of the Topcat that the components are
registered with for proper disbursement.
To assist in this process, Lightspeed has labeled each registered component with a system
number. If components become separated, simply match them up by this number for proper
operation. Additional system labels are attached to the Quick Start Guide should you add
components, or if one of your original components should need to be replaced.