Warning:
Read these instructions carefully! Failure to follow them could cause damage to the product or
cause a hazardous condition.
General Safety Information:
Do not use this product on circuits exceeding 30 VAC. Higher voltage will damage this control
and could cause electrical shock or personal injury.
1. Installer must be a trained, experienced service technician familiar with the system this
product will control.
2. Disconnect all power before beginning installation to prevent electrical shock or
equipment damage.
3. Control voltage and current ratings must fall within the range outlined in
“specications.”
4. Verify that the relay load does not exceed 1 amp. Excessive load will damage the solid
state switch.
Thermostat Placement:
Mount your thermostat vertically about 5 feet above the oor in an area that has good air
circulation at average room temperature. Be sure to locate the thermostat where it will be
exposed to lights that are normally on when the room is occupied.
Locate the thermostat away from:
• Outside walls and drafts
• Doors, windows, and direct sunlight
• Supply air ducts, radiators and convectors
• Applicances that produce heat or cool air
2
To Next Page
Loading...