Page 15 of 36
KA20IC - Start-up (How to pair Bluetooth connection)
It is possible to pair multiple devices to the KA20IC via Bluetooth
®
. See following instructions:
1. Pairing your control
Connect the KA20IC to the mains using the SMPS. Now the KA20IC will be in pairing mode in 3 minutes and the
Under Bed Light will blink to indicate this.
Take you hand control and press the 2 top buttons at the same time. Now the light will give a long blink and indicate
that the control and the KA20IC are paired up. The KA20IC will stay in pairing mode and it is possible to connect
more controls using the same procedure as above. Be aware; you have to wait 5 seconds after pairing control 1 until
you can pair control number 2. To get the system out of pairing mode – simply press any button on an already paired
device.
When you operate the KA20IC with the two controls you need to wait 5 seconds from operating with control 1 until
you can operate control 2.
1
2
3
2. Pairing your smartphone or tablet
Connect the KA20IC to the mains using the SMPS. Now the KA20IC will be in pairing mode in 3 minutes and the
Under Bed Light will blink to indicate this.
Enable Bluetooth
®
on your smartphone/tablet. Open the Bed Control App and a “search bed” page will be
displayed. A list of previously connected KA20IC and KA20IC in pairing mode will appear. Find the KA20IC you
wish to connect on the list and tap to connect. The smartphone/tablet and the KA20IC are now paired up and the
app will display the operation page.
1
2
3
To Next Page
Loading...
Need help?
General
