To Next PageTo Next Page
Need help?Do you have a question about the Lincoln Electric INVERTEC PC 65 and is the answer not in the manual?
General| Brand | Lincoln Electric |
|---|---|
| Model | INVERTEC PC 65 |
| Category | Welding System |
| Language | English |
Covers primary warning symbols, electrical hazards, EMF, and material safety precautions.
Includes setup, location, duty cycle, and connection procedures for safe operation.
Highlights the necessity of the torch protection sleeve for safe operation.
Details the controls and indicators specific to the INVERTEC PC65 model.
Details the controls and indicators specific to the INVERTEC PC105 model.
Explains the remote ON/OFF switch, connector, and torch connection for operation.
Describes output connector, power switch, and input cable connection.
Details gas supply, pressure regulation, and the cooling fan operation.
Advises contacting authorized service for repairs and outlines basic checks.
Provides a table of cutting speeds for different materials and thicknesses, listing influencing factors.
Explains EMC principles, potential disturbances, and methods to reduce emissions.
Details input voltage, power, and frequency requirements for the machines.
Lists output voltage, current, and duty cycle ratings at 40°C.
Specifies the required inlet pressure for compressed air or gas.
Recommends input cable types and fuse/circuit breaker sizes.
Provides height, width, length, and weight specifications for each model.
Lists the acceptable operating and storage temperature ranges.
Guides users on how to read and interpret the spare parts list and assembly pages.
Illustrates the physical components of the INVERTEC PC65 machine.
Lists part numbers and descriptions for the INVERTEC PC65 assembly.
Illustrates the physical components of the INVERTEC PC105 machine.
Lists part numbers and descriptions for the INVERTEC PC105 assembly.
Provides the wiring diagram for the INVERTEC PC65 plasma cutting machine.
Provides the wiring diagram for the INVERTEC PC105 plasma cutting machine.
