To Next PageTo Next Page
Need help?Do you have a question about the Lincoln Electric MAGNUM 250 and is the answer not in the manual?
General| Processes | MIG, Flux-Cored |
|---|---|
| Output Amperage Range | 30 - 250 A |
| Duty Cycle | 60% at 250 A |
| Wire Feed Speed Range | 50-700 IPM |
| Rated Output | 250 A at 30 V |
| Wire Diameter Range | .023 - .045 in |
Initial safety message and reading manual importance.
Covers Proposition 65, EMF, electric shock, fumes, fire, cylinder safety.
Details gun/cable assemblies and connector kit compatibility.
Lists specifications for PRO 250 and 350 models.
Lists specifications for PRO 450 and 550 models.
Instructions for installing various K466 connector kits.
Procedures for installing and trimming gun liners.
How to install contact tips and gas nozzles.
Connecting guns to various wire feeders.
Information on suitable electrodes and equipment.
Step-by-step guide for performing a weld.
Tips for avoiding and resolving wire feeding issues.
Instructions for liner removal, installation, and trimming.
Procedures for cleaning and maintaining gun tubes and nozzles.
Details on cleaning, repairing, and replacing gun cables.
Steps for repairing the wire feeder end of the cable.
How to use the troubleshooting guide.
Common problems and remedies for wire feeding.
Diagnosing and fixing arc striking and porosity issues.
Causes and solutions for tip seizing in the diffuser.
