Lincoln DOUBLE - TV Installation Instructions; Connecting TV Lift Power and Media; Adjusting and Securing TV Mount; TV Lift Operation

TV Installation Instructions:
Before fixing the slats to the Bedstead, please follow the television installation instructions below:
1.
Connect the power lead (12) to the socket located at the bottom of the footboard (2) then connect to
the wall socket. The wall socket must of an earthed type for safety reasons. Connect media using the
x2 HDMI cables & the 4m aerial cable.
2.
Raise the TV lift by pressing one of the UP buttons located on either side rail of the bed (TOP half of the
switch).
3.
Unpack the television and if there are any TV mounting screws fitted, please remove them. Use the
screws supplied in the TV installation kit or those supplied with TV but make sure they are fitted
correctly. If your TV mounting is 100 x 100,removethe two brackets and use the cone shaped screws
throughbrackets into TV firs
t, then re- fit the brackets with the thumb- screws.
4. If necessary you can adjust the bracket up and down to align with the screw fixing points, by
loosening the thumb screws on the back of the TV Lift and aligning the brackets with the
fixing holes.
5.
Carefully tighten the screw ( M ) using the allen key ( N )-the screws & allen key can be
found in the TV Installation kit, in the main hardware pack inside the accessory box.
6.
Connect the power and aerial cables to the television making sure the cables are not
loose. If necessary use cable ties & spare clips to route cables safely- carefully follow
main instructions in this guide.
7.
The television can now be operated following the TV Operation Manual.
8. To lower the television back into the footboard, press one of the side panel DOWN
buttons (BOTTOM half of the switch). Wh
en DOWN button is pressed, TV will retract
into footboard and turn off automatically at the bottom.
9. When UP button is pressed- TV rises and turns itself back on automatically. Occasionally
you may need to press button twice..
Troubl e shootin g
1.
If your television does not operate please check all the power connections, both to
the wall and to the socket in the footboard. Make sure TV is switched on. Note: TV
will only work when it is in the up position.
2. If the TV Lift does not operate, try each switch in turn. If neither switch operates press
the button twice. Check that the power to the controller is on.
3.
If the television or TV Lift still fails to operate there may be a problem that can be
checked by our technicians. Call Customer Services for help and information (see
page 2).
IMPOR
TANT : Care should be taken when connecting electrical items.
Page 9 of 13