Sounding a panic alarm
Press
to activate the alarm. The horn will sound and the turn lamps
will flash for a maximum of 3 minutes. Press again or turn the ignition to
the 3 (RUN) position to deactivate, or wait for the alarm to timeout in 3
minutes.
Note: The panic alarm will only operate when the ignition is in the 1
(LOCK) position.
Opening the trunk
Press once to open the trunk.
• Ensure that the trunk is closed and latched before driving your
vehicle. Failure to properly latch the trunk may cause objects to fall
out or block the driver’s rear view.
Memory seat feature (if equipped)
The Integrated Keyhead Transmitter allows you to recall the memory
seat/mirror feature.
Press
to automatically move the seat/mirror to the desired memory
position. Note: The seat will not travel to their final position if the key is
not in the ignition and the easy entry feature is enabled.
Activating the memory feature
To activate this feature:
1. Position the seat and mirrors to the positions you desire.
2. Press the SET control on the
driver’s door panel.
3. Within 5 five seconds, press any
control on the Integrated Keyhead
Transmitter and then press the 1 or
2 control on the driver’s door panel
to associate with the Driver 1 or
Driver 2 positions.
4. Repeat this procedure for another
Integrated Keyhead Transmitter if
desired.
SET
12
2006 Zephyr (378)
Owners Guide (post-2002-fmt)
USA (fus)
Locks and Security
79
To Next Page
Loading...
Need help?
General
