Section 6
Page 3
Service Training
6.1 TRACTION
6.1.1 Description and operation
ATTENTION: Before starting any work on the control system, always disconnect the battery connector. Non-
compliance with this procedure could damage the CAN interface controls. DO NOT remove or replace the
components when the truck is switched on.
6.1.1.1 Speeds / reduction of speeds
Stand-on pallet stacker speed => lowered platform and raised guard rail / SP version => 10Km/h
Stand-on pallet stacker speed => lowered platform and lowered guard rail => 8Km/h
Pedestrian pallet stacker speed => raised platform and lowered guard rail => 6Km/h
Speed reduced on turning => 6Km/h
Speed reduced / anti-crush 1S3 activated => 4Km/h
Speed reduced / battery unlocked => 2Km/h
Speed reduced / stabiliser oil level too low => 2Km/h
6.1.1.2 Tiller rear safety control 1S3
By activating the tiller safety contact, the truck moves in the direction of the fork arms at reduced speed while the tiller
safety switch is not released. Once released, the truck is in safety and can restart only if the accelerator throttle moves
back to neutral position. The anti-crash safety can be activated or deactivated with the lowered platform (stand-on).
6.1.1.3 Control for lowering fork arms - 2S7
In SP and AP versions, in the lowered platform configuration, the lowering of the fork arms is possible only if the driver
is present on the platform.
https://www.besttruckmanuals.com/
To Next Page
Loading...
