Lindner URRACO 75 D - Page 17

URRACO 75 D 

 O PERATION OF THE S HREDDER
Managing director
LINDNER
Mobile Shredder GmbH
Industriestrasse 1A
D-99820 Hörselberg / Eisenach
Service hotline:
+49 (0) 36920 - 7269 - 600
service@l-ms.de
Manuel Lindner
Gerhard Buhl
Walter Geiger
Page - 17 - of - 33 -
 Switching on the remote control
During normal operation, the shredder is controlled exclusively by means of the remote
control. To switch on the remote control, proceed as follows:
S
S
w
w
i
i
t
t
c
c
h
h
i
i
n
n
g
g
o
o
n
n
t
t
h
h
e
e
r
r
e
e
m
m
o
o
t
t
e
e
c
c
o
o
n
n
t
t
r
r
o
o
l
l
N
N
o
o
.
.
A
A
c
c
t
t
i
i
o
o
n
n
(
(
s
s
)
)
R
R
e
e
s
s
u
u
l
l
t
t
N
N
o
o
t
t
e
e
s
s
Prerequisites:
 The drive engine is switched on (see -Starting the engine).
 Set the key switch on the operating panel to "Automatic".
 The remote control transmitter is fully charged.
Safety
instructions:
 No persons within the danger area!
1
Pull out emergency stop, press
buttons 9 and 10 (lift magnet and lower
magnet) on radio remote controls
simultaneously until LED battery /
radio connection is on.
Radio connection is active
If the transmitter shows
stopping and switches off, no
radio connection could be
established.
2
On the operating panel in
automatic operation, activate the
button "Automatic operation
without remote control"
The icon changes its colour and the
text now says "Automatic operation
with remote control"
The functions on the remote control
system can now be executed.
Leave the danger area immediately!
If the transmitter is not
switched on, the error
message "Emergency stop
remote control activated" is
shown. Switch on transmitter
as described in 1.
3
Press button (automatic on) on
the radio remote controls.
 The icon "Switch off automatic
operation" appears on the
operating panel.
 The tool shafts, discharge
conveyor belt, water sprinkler
(option) and overbelt magnet
(option) are automatically switched
on.
Automatic mode is active.
Leave the danger area
immediately!