Lindner URRACO 75 D - Control of the Shredding Tool Speed

URRACO 75 D 

 O PERATION OF THE S HREDDER
Managing director
LINDNER
Mobile Shredder GmbH
Industriestrasse 1A
D-99820 Hörselberg / Eisenach
Service hotline:
+49 (0) 36920 - 7269 - 600
service@l-ms.de
Manuel Lindner
Gerhard Buhl
Walter Geiger
Page - 32 - of - 33 -
Note that improper modifications may cause damage to the shredder or its
components and our warranty will cease to apply.
It may be necessary to change these settings according to the material to be shredded.
In this case, please contact the Service Department of - LINDNER GmbH.
Phone: + 49 (0) 36920 - 7269 - 600
1.5.-12 Control of the Shredding Tool Speed
The rotational speed of the shaft can also be changed in the setpoint value menu. The
procedure is the same as for setting the switching points.
Value 100 % of the shredding tool speed is set in the data block by the manufacturer.
During the commissioning of the shredder, the Service engineers of LINDNER GmbH can
adjust the times set by the manufacturer to suit the actual application conditions.
Contact the Service Department of LINDNER GmbH before making any
changes to the set times as otherwise the performance of the shredder may be
impaired.
The automatic mode must be switched off before the times and values are
changed.