Lindner URRACO 75 D - Page 27

URRACO 75 D 

 O PERATION OF THE S HREDDER
Managing director
LINDNER
Mobile Shredder GmbH
Industriestrasse 1A
D-99820 Hörselberg / Eisenach
Service hotline:
+49 (0) 36920 - 7269 - 600
service@l-ms.de
Manuel Lindner
Gerhard Buhl
Walter Geiger
Page - 27 - of - 33 -
S
S
t
t
a
a
r
r
t
t
i
i
n
n
g
g
t
t
h
h
e
e
a
a
u
u
t
t
o
o
m
m
a
a
t
t
i
i
c
c
m
m
o
o
d
d
e
e
No. Action(s) Result Notes
The functions on the remote
control system can now be
executed.
Leave the danger area
immediately!
in1.
3
Press button (automatic on) on
the radio remote controls.
 The icon "Switch off
automatic operation"
appears on the operating
panel.
 The tool shafts, discharge
conveyor belt, water
sprinkler (option) and
overbelt magnet (option)
are automatically switched
on.
Automatic mode is active.
Leave the danger area
immediately!
When the automatic mode has been started, the shredder is ready for operation and material
can be fed into the hopper.
Empty the tilting hopper as required by pressing the buttons (Hopper) and (Hopper 2 up) on
the remote control.
You may also have to use the functions "Reverse" or "Forced Reverse".
If (Reverse) is pressed on the remote control, the shafts run in reverse as long as the button
is pressed.
The function "Forced reversing" can be configured depending on the material. It ensures that
the shafts are regularly cleaned by forcing them to run in reverse after a defined period of
time.
Contact our service department before using "Forced Reverse" to prevent any
loss of performance.