Presets, Tuner & Pedal
4•3
That’s it. Now, when you turn the Amp Models, Effects or Delay knob to this position,
you’ll instantly get your personal settings, with all the controls set the way you like them.
There’s one thing to note. You’ll notice that you didn’t get to pick a location to save your
custom setup. That’s because Floor POD Plus will only save to the knob position of the
currently selected Amp Model, effect or delay. For example, if you started with the Line
6 Insane Amp Model, saving a custom amp setup will save to the Line 6 Insane knob
position.
Tuner
Press and hold the Tap footswitch for 2 seconds to enter tuner mode. The Tuner light will
light to let you know you’re in tuner mode. Play a note on your guitar and Floor POD Plus
will show you its pitch by displaying the note name in the display. All notes are displayed
as naturals or flats, so you’ll see “A
b
” instead of “G
#
” and so on.
The lights under the display tell you if the note is sharp or flat. If the
b
light is lit, then
you’re flat. If the
#
light is lit, now you’re sharp. When all three are lit up, you’re in tune.
To exit tuner mode, press the Save or Manual button or the Tap footswitch.
Tuner Reference Frequency
When in Tuner Mode, you can change the tuner reference frequency by using the Bank
Up/Down footswitches. By default, the unit has a tuner reference frequency of A440, but
it can be adjusted from A436 to A445. The display will show you the frequency selected.
This setting is automatically saved and will be recalled the next time you enter Tuner
Mode.
Tuner Volume Level/Mute
When in Tuner Mode, you can also select whether you want your sound to be muted or
pass through at a given volume. The pedal Toe Switch toggles tuner volume mute on
and off. When tuner volume mute is off (and the Wah light is lit), you can set the pass-
through volume by using the Vol/Wah pedal. This setting is automatically saved and will
be recalled the next time you enter Tuner Mode.
To Next Page
Loading...