Need help?Do you have a question about the Line 6 POD HD300 and is the answer not in the manual?
General| Amp Models | 16 HD amp models |
|---|---|
| Display | LCD |
| Type | Multi-Effects Processor |
| Number of Models | 16 amp models |
| Computer Connectivity | USB |
| Footswitches | 4 |
| USB | Yes |
| Power Supply | Included |
| Effects Types | Distortion, modulation, delay, reverb |
| Presets | 128 |
| Cabinet Models | 16 cab models |
| Expression Pedal | Built-in expression pedal |
| Effects | 80+ M-class effects |
Configure system settings for POD HD, including global options and initial setup.
Control output signal type, automatic FX behavior, and USB monitor volume.
Define footswitch operation and set AC rate for amp authenticity.
Adjust tap tempo light, view firmware version, and calibrate the expression pedal.
Reset the device to factory defaults, including pedal calibration, for a clean slate.
Access the onboard chromatic tuner for precise instrument tuning.
Quickly load and customize effects using the intuitive Smart FX controls.
Manage unwanted noise with the Noise Gate and control volume via pedal or settings.
Integrate external effects, set tempo, and assign expression pedal functions.
Connect additional pedals, link to Line 6 amps, and configure audio output modes.
Select optimal output modes for various scenarios like amp connection or recording.
Utilize the free software for creating, editing, backing up, and managing presets.
Navigate and load stored presets using device controls and footswitches.
Utilize footswitches for hands-free preset selection and bank management.
Save current tone configurations as new presets or overwrite existing ones.
Enter Edit Mode to adjust detailed tone parameters and fine-tune settings.
Access system, amplifier, and effect menus for comprehensive tone editing.
Adjust specific parameters for Reverb, Noise Gate, Wah, and Volume effects.
Configure FX loop settings and manage MIDI SysEx data for preset backup.
Understand amp tone parameters and select from various amp models.
Review default cab/mic assignments and the list of available models.
Customize amp settings and select between full or preamp amp modes.
Choose specific speaker cabinet and microphone models for amp configurations.
Adjust room tone, bypass volume level, and utilize manual mode for knob control.
Bypass amp processing for FX-only use or configure automatic FX adjustments.
Explore amp models and understand unique control knob behaviors for specific amps.
Comprehensive parameters for FX1 category effects like distortions and compressors.
Specific parameters for Gain, Various (Reverb), and Pitch FX subcategories.
Detailed parameters for FX2 category effects like modulation, filter, and tremolo.
Detailed parameters for FX3 category effects like delays and echoes.
Parameters for Reverb effects and list of Wah models with pedal usage.
Operate the built-in looper, including recording, overdubbing, and playback functions.
Install necessary drivers and configure the device for use as a USB audio interface.
Manage audio signal flow for recording and monitoring via the USB connection.
Adjust the balance between the guitar monitor signal and computer playback audio.
Configure Mac audio driver settings using the Audio-MIDI Setup utility.
Configure Windows audio driver settings via the Control Panel.
Install, log in to, and register your Line 6 hardware using the Monkey software.
Check for and install the latest driver, firmware, and application updates for your device.
Understand MIDI SysEx for preset management and identify required software utilities.
Perform MIDI dumps to back up and restore presets using external MIDI software.
To Next Page
