Setup Details
1•1
Setup DetailS
In this chapter, we’ll cover the options found within the POD® HD300 & POD® HD400
Setup screen, calibrating your device’s on-board pedal, and performing a Factory Reset.
This Guide covers POD HD300 & HD400 devices with Flash Memory version 1.10
installed. It is highly recommended to use Line 6 Monkey™ to install the latest available
Flash Memory version & all available updates - See “Appendix A: Line 6 Monkey™”
on page A•1
. Details throughout this Guide pertain to both POD HD300 & HD400, unless
otherwise noted.
Setup Options
The Setup screen is where you configure system settings for POD HD. Most options can be
left as-is after you’ve set them initially. They’ll be recalled each time you power-up and are
“global” (the settings persist regardless of the current Preset). To access the Setup options,
press the PRESETS knob, and use the Nav. Disc Left/Right arrow buttons to navigate to
the SETUP menu:
Use Up/Down to
select the next/previous
SETUP parameter
Use Left/Right to navi-
gate to SETUP menu
Press knob to enter
EDIT mode
Rotate the knob to
change the setting for
the selected parameter
To Next Page
Loading...
Need help?
General
