Need help?Do you have a question about the Line 6 HX Stomp and is the answer not in the manual?
General| DC-in jack | Yes |
|---|---|
| USB 2.0 ports quantity | 1 |
| Connectivity technology | Wired |
| 6.35 mm (1⁄4-inch) input | 2 |
| Display type | LCD |
| Power source type | DC |
| Product color | Black |
Defines key terms and concepts used throughout the manual, essential for understanding the HX Stomp.
Provides instructions for downloading and installing the latest firmware to ensure optimal performance and features.
Illustrates various methods for connecting the HX Stomp to other gear, including pedalboards and amps.
Guides users on how to navigate banks and select presets using footswitches or the Upper Knob.
Explains how to access and navigate the preset list to find and select presets.
Details how to select block models and toggle blocks on/off within a preset.
Explains the concepts of serial and parallel signal paths for complex tone creation.
Discusses Dynamic DSP limitations and provides tips for optimizing performance.
Lists and describes distortion and dynamics effect models available in the HX Stomp.
Details EQ, modulation, and other effect model categories available on the HX Stomp.
Lists and describes delay and reverb effect models available in the HX Stomp.
Details filter, pitch/synth, and wah effect model categories available on the HX Stomp.
Explains how to change amp models within an Amp+Cab block.
Explains how to change cab models within a Cab block.
Lists available microphone models used for Impulse Response capture.
Details parameters for configuring Impulse Response blocks.
Configures parameters for using the Send/Return jacks as an FX loop.
Explains settings for the Looper block, including playback and overdub.
Details settings for Y, A/B, and Crossover split blocks.
Explains what snapshots are and their function in managing preset variations.
Guides users on how to select and adjust snapshots from the Play view.
Configures how snapshot edits are handled (Recall vs. Discard).
Provides methods for copying and swapping snapshots between locations.
Offers creative ideas for utilizing snapshots in musical performances.
Assigns blocks to footswitches for quick bypass control.
Details manual assignment of bypass behavior to switches or pedals.
Removes bypass assignments from blocks or all blocks.
Allows quick reordering of footswitch assignments between switches.
Explains how to assign expression pedals or footswitches to control parameters.
Removes controller assignments from blocks or all blocks.
Offers tips for effectively using controllers for dynamic tone shaping.
Restores the Global EQ settings to their factory default state.
Guides on matching input/output levels for optimal tone and noise performance.
Resets all global settings to their factory defaults.
Compares hardware and DAW monitoring for latency and workflow.
Explains how to record a clean DI guitar signal for later processing.
Details the process of re-amping recorded DI tracks using HX Stomp.
How to recall presets and snapshots using MIDI messages.
Controlling block bypass and parameters via MIDI.
To Next Page
