Setup Details
1•4
Tap Tempo Light
• TpLite - AlwaysOn: The TAP light on the device will flash constantly, showing the
current tempo setting.
• TpLite - AlwaysOn: The TAP light will flash only 8 times, immediately after a new
Tempo value is set, and then remain unlit.
Firmware Version
Your device’s current firmware-flash memory version is displayed here. This is an
informational screen only.
Pedal Calibration
Note: If you’ve just performed a Factory Restore on your device (see below), that process
included Pedal Calibration and it is not necessary to perform the following steps again.
However, you can use these instructions to perform just the Pedal Calibration process at
any time.
Before you put the POD HD pedal to use, it is recommended that you calibrate it to
optimize its functionality. Begin with POD HD powered off. Hold down the D footswitch
while powering the unit on, until you see the LCD display the following:
Please skip ahead to step 5 of the Factory Restore section on page 1•5 and follow the
remaining steps to complete the Pedal Calibration.
To Next Page
Loading...
Need help?
General
