Line 6 POD HD300 User Manual

Setup Details
1•5
Factory Restore
To restore POD HD to all its original factory settings, first back up any Presets you’d like
to keep (“POD HD Edit Software” on page 2•7), then follow these steps:
NOTE: This process also performs a Pedal Calibration, and it is necessary that you
complete ALL the steps listed here when dong a Factory Restore. However, if you want to
perform only a Pedal Calibration, please see “Pedal Calibration” on page 1•4.
1. Begin with POD HD powered off. Hold down the A footswitch while powering the
unit on, until you see the LCD display the following:
2. Press the PRESETS knob, then press it again to proceed once you see the following
prompt:
3. Watch the LCD screen and you’ll see it display the progress %. Do not touch any
controls on the device during this process.
4. Once it reaches 100%, you are prompted to start the Pedal Calibration process. Press
the D footswitch to proceed.
5. You are next prompted to press and hold the pedal’s “toe” switch:

Line 6 POD HD300 Specifications

General

Amp Models	16 HD amp models
Display	LCD
Type	Multi-Effects Processor
Number of Models	16 amp models
Computer Connectivity	USB
Footswitches	4
USB	Yes
Power Supply	Included
Effects Types	Distortion, modulation, delay, reverb
Presets	128
Cabinet Models	16 cab models
Expression Pedal	Built-in expression pedal
Effects	80+ M-class effects