Line 6 Floor POD Plus - System Reset and Pedal Calibration

Presets, Tuner & Pedal
4•4
Complete Factory Reset
If for any reason, or just for the sheer mad joy of it, you decide you need to reset your
Floor POD Plus’s entire memory to its factory-programmed state, then boldly do this:
Simultaneously press the Bank Up and Bank Down footswitches while plugging in the
power supply. After startup, the display will show “int”, to indicate that the unit has been
re-initialized. Disconnect the power supply then reconnect it. You’re done.
Calibrating the Vol/Wah Pedal
To make sure the pedal on your Floor POD Plus has the most sensitivity and range possible,
do the following:
Unplug the power supply, then press and hold the Toe Switch on the Vol/Wah pedal
while reconnecting the power supply. The display will show “ PC” to indicate Pedal
Calibration Mode, then ”000”.
With the pedal in the toe (maximum) position, press Footswitch A. The display will
scroll to “100”.
With the pedal in the heel (minimum) position, press Footswitch B. The display will
scroll to “100”.
Press Footswitch C. The display will show a numerical value.
Press pedal Toe Switch, then move the pedal from heel to toe positions and observe
the lights around the Effects encoder. The number of lights should reflect the pedal
position.
Press-and-hold the Tap footswitch for two seconds to save the calibration.
Unplug the power then plug it back in. You’re there!
•
•
•
•
•
•
•