F
RONT
P
ANEL
C
ONTROLS
2 • 8
Delay effect. More Delay details are in the
Effects Chapter
.
Presence Bump On/Off (Treble Knob):
Hold down, and
keep holding
down
, the
Ta p
button as you turn the
Treble
knob up past twelve o’clock, and you
get a Presence boost, brightening your tone. Same as the
EQ
boost on the Floor
Board (details in
Chapter 8
). As you do this, the Channel C light comes on if
you turn the Presence “circuit” on.
Volume Boost On/Off (Chan Vol Knob):
Hold down, and
keep holding
down
, the
Ta p
button as you turn the
Chan Vol
knob up past twelve o’clock, and
a Volume Boost kicks in. This boosts volume without extra ‘dirt’ – like for a lead
boost. This is the same as kicking on
Drive/Boost
at the Floor Board (details in
Chapter 8
). As you do this, the Channel B light comes on if you turn the Drive
Boost on.
Digital Out Gain (Reverb Knob):
This control allows you to add extra gain at
your POD’s digital output. This is useful when you are recording with clean or other
low level tones. For instance, if you have the
Drive
knob set low and your tone
controls turned low as well, you may find that you aren’t able to get your digital out
level near peak even with the
Channel Volume
knob at max. This is because you
aren’t getting the gain contribution of the Drive control, and the gain boosts of the
tone controls. We’ve provided you with extra gain in the digital domain to
compensate for this, so that you can get a hot digital output from your POD with
this sound. To do this, hold down, and
keep holding down
, the
Ta p
button as you
turn the
Reverb
knob to set the volume level at POD’s digital outputs. Turning
this knob to max adds an extra 12dB of gain at the digital out to help you get full-
level digital output with clean or lower volume sounds. Turning this control to
minimum adds no extra gain to the digital output.
Please note that when you add
extra gain here, it IS possible that you could clip the digital output if you are
using a high gain sound
, so be sure to monitor the digital output signal as you are
recording to insure everything’s hunky dory.
Effect Speed (Effect Tweak Knob):
Hold down, and
keep holding down
, the
Ta p
button as you turn the
Effect Tweak
knob to fine tune the current Effect’s
speed. More Effect details are in the
Effects Chapter
.
POD Pro Manual Ch. 2 - Rev C Page 8 Monday, September 11, 2000 10:57 PM
To Next Page
Loading...