LIVE SETUPS: LIVE/STUDIO MODE SWITCH
4 • 1
LIVE SETUPS
If you’re going to be using your POD as a preamp with your power amplifier and speaker
cabinets, and or for its direct output to a house mixer, P.A. or other live performance
sound system, here’s what you need to know to get set up:
LIVE/STUDIO MODE SWITCH
The first thing to do is check the rear of your POD, and make sure you have the
Live/Studio Mode switch set to the Live position. This determines how your
POD will configure its outputs and signal processing.
INPUTS
Your POD includes two inputs – a front panel guitar level input, and a rear panel
line level input. You select which of these inputs you want to use by flipping the
Input Select Switch on the front panel.
Guitar Input – This is just like the guitar input on your standard guitar
amplifier or preamp. Plug one end of a guitar cable into your guitar, and
connect the other end here. Be sure to set the front panel Input Select switch
to the Guitar Input position.
Line Level Input – The Line Level Input on the rear panel is under the
boxed label “Re-Amping Input-Output.” This jack is designed for line level
2
3
To Next Page
Loading...