THAT’S USING YOUR FEET: USING THE FLOOR BOARD WITH POD
7 • 3
Channel Select
So, now that we’ve got this whole Bank thing down, let’s move onto the other four
switches on the bottom row. These let you pick which of the four channels – A, B,
C, or D – you want to use in the bank you’ve selected. Pick your Bank , hit
one of the Channel Select switches , and you’re ready to roll.
Manual Mode
Hey, what about Manual Mode? Don’t worry – you can get there any time. Let’s
say you’re into a Memory Bank, and have a particular Channel selected. The
channel’s corresponding LED is lit above its Floor Board Channel Select switch,
right? OK, step on this switch a second time and hold it for at least a second.
Boom! You'll find yourself transported directly to Manual Mode. To get back out of
Manual Mode, press either Bank Up or Bank Down foot switch and you’ll be
switched right back to wherever you were when you entered.
Editing and Saving POD Channels with the Floor Board
The basic story on editing the programmable POD channels is in the POD
Effects Chapter. With a Floor Board you’ll find that the display will show an
E (for “Edited”) whenever you’ve edited a channel. It will display an S (Save) if
you press the Save button on your POD in preparation for saving a channel. When
you decide you want to save an edited channel, you can select any of the locations
via the Floor Board as your destination. Here’s how:
1. EDIT A CHANNEL’S SETTINGS TO YOUR LIKING.
2. PRESS THE SAVE BUTTON ON YOUR POD.
3. P
ICK THE MEMORY BANK YOU WANT TO STORE TO WITH THE BANK UP AND BANK
DOWN SWITCHES ON THE FLOOR BOARD.
4
A.ON YOUR POD, PICK THE CHANNEL MEMORY LOCATION (A, B, C, OR D) YOU WANT
TO SAVE TO WITHIN THE SELECTED BANK, AND
5. PRESS THE SAVE BUTTON TO COMMIT YOUR MASTERPIECE TO YOUR POD’S MEMORY.
O
R,
4
B.SKIP 4A AND 5, AND JUST KICK YOUR CHOSEN FLOOR BOARD CHANNEL SELECT
SWITCH TWICE TO SAVE INTO THAT CHANNEL.
24
28
25
To Next Page
Loading...