Linear DVS-2400 - Force Arming Reporting Code; Duress Reporting Code

Black 0041
Black0041
FORCE ARMING REPORTING CODE
◆
Programming Step #258
◆
The factory set reporting code for force arming is
“65” (Code 574 with Ademco).
◆
Any value from 0-99 can be programmed for
this event (0 = no report).
✍
NOTE: For force arming reporting, force arming
reports must be enabled. See Page 37.
DURESS REPORTING CODE
◆
Programming Step #259
◆
The factory set reporting code for Duress is “66”
(Code 121 with Ademco).
◆
Any value from 0-99 can be programmed for
this event (0 = no report).
✍
NOTE: For duress code reporting a keypad duress
code must be programmed. See Page 30.
5
JKL
9
WXY
HOME
AWAY
0 - 99 FOR DURESS CODE
PROGRAMMING STEP #259
PROGRAM
STORE PROGRAM
2
ABC
5
JKL
8
TUV
HOME
AWAY
0 - 99 FOR FORCE ARMING
REPORTING CODE
PROGRAMMING STEP #258
PROGRAM
STORE PROGRAM
2
ABC
OPENING & CLOSING REPORTING CODES TABLE
USER CODE
4 x 2 CLOSING
(ARMING) CODE
4 x 2 OPENING
(DISARMING) CODE
ADEMCO CLOSING
(ARMING) CODE
ADEMCO OPENING
(DISARMING) CODE
MASTER USER CODE 74 82 R401 C000 E401 C000
RESTRICTED USER CODE #1 75 83 R401 C001 E401 C001
RESTRICTED USER CODE #2 76 84 R401 C002 E401 C002
RESTRICTED USER CODE #3 77 85 R401 C003 E401 C003
RESTRICTED USER CODE #4 78 86 R401 C004 E401 C004
RESTRICTED USER CODE #5 79 87 R401 C005 E401 C005
PAGE ALERT USER CODE (DIALS PAGE NUMBER ONLY, NO CODES REPORTED)
REMOTE/HARDWIRE ARM (SENSOR TYPE 9) & QUICK ARM 81 R407 C007
REMOTE/HARDWIRE DISARM (SENSOR TYPE 9) 89 E407 C007
Opening & Closing Reporting Codes Table
SYSTEM REPORTING CODES
STEP #
PROGRAMMING
FUNCTION
POSSIBLE
4 x 2 VALUES
FACTORY
4 x 2 VALUE
ADEMCO
VALUE
INSTALLATION
4 x 2 VALUE
261 SYSTEM FIRE REPORT CODE 0 - 99 68 110
262 SYSTEM EMERGENCY REPORT CODE 0 - 99 69 120
263 SYSTEM TEST/CANCEL REPORT CODE 0 - 99 70 406
264 SYSTEM LOW BATTERY RESTORAL REPORT CODE 0 - 99 71 R302
266 SYSTEM LOW BATTERY REPORT CODE 0 - 99 73 E302
258 FORCE ARMING REPORT CODE 0 - 99 65 574
259 DURESS REPORT CODE 0 - 99 66 121
System Reporting Codes Table
39