EasyManua.ls Logo

Linhai Crossfire E5 2022 - Choke Adjustment; Toe Alignment Check and Adjustment

Linhai Crossfire E5 2022
99 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CHAPTER 2 MAINTENANCE LH50DU SERVICE MANUAL 19.1
CHAPTER 2 MAINTENANCE PAGE. 2-
7
2.3 CHOKE ADJUSTMENT
If the choke knob does not stay out when pulled,
adjust the choke tension by tightening (clockwise)
the chock cable boot until the choke slider freely but
stays out when pulled.
If smooth choke operation is not obtainable, inspect
choke cable for kinks or sharp bends in routing
2.4 TOE ALIGNMENT
METHOD: STRAIGHTEDGE OR STRING
Be sure the steering wheel in a straight ahead
position.
NOTE: String should just touch side surface of rear
tire on each side of the CUV.
Measure from string to rim at front and rear of rim.
Rear rim measurement (A) should be 1/8" to 1/4" (3
to 6 mm) more than front rim measurement (B).
Always pay attention to tie rods assembly, Both ends
must screw in same and enough threads length.

Related product manuals