Link Controls CDO 100: 1:10-30 - Initial Operation; 6.1 Preparation and Connections

Door Operator / STA / LC- 2973 Rev.H– 9
6. Initial Operation
6.1 Preparation
Warning!
To avoid damage to the operator, the
following points must be observed:
- The types of cable and their diameters
must be selected according to current
regulations.
- The nominal currents and the type of
connection must correspond to those on
the motor type plate.
- The drive details must agree with the
connected loads.
Information:
When operated with electronic control
units, the corresponding start-up
instructions and circuit diagrams must be
complied with.
6.2 Motor & Limit Switch Connections
Open the operator
☞ Remove the cover from the operator.
Insert the cables
☞ Feed the cables through the gland tting into the
operator.