Link4 iPonic 614 - Page 2

Link4 iPonic 614

52 pages

Save Page as PDF

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

960-3100-00 iPonic 614 Installation Manual II

Table of Contents

Default Chapter3
- Table of Contents3
Introduction7
- Customer Service7
- Contact Us7
Warranty8
Mounting and Installation9
- Content Inspection9
- Mounting the Iponic TM 6149
- Connecting the Indoor Sensor Module10
- Connecting to the Internet10
- Internet Setup11
- Equipment Setup12
- Navigation13
- Equipment Selection13
- Equipment Installation13
Time Setpoints14
- Changing Day/Night Setpoints14
Light Control15
- Lighting Equipment Setup15
- Changing Light Settings15
CO 2 Control15
- CO 2 Injector Setup15
- Changing CO Target Settings15
Temperature Control15
- Heater Setup15
- Ventilation Fans Setup16
- Air Conditioner Setup16
- Central Heating and Air16
- Temperature Setpoints16
- To Switch between Degrees Fahrenheit and Degrees Celsius16
- To Change the Cooling and Heating Setpoints16
Humidity Control16
- Dehumidifier Setup16
- Humidifier Setup17
- Humidity Setpoints17
- To Change the Humidifying and Dehumidifying Setpoints17
Irrigation17
- Irrigation Pump Setup17
- Irrigation Settings17
Alarms18
Alarm Function18
- Changing the Alarm Settings18
- Receiving Alarm Notifications by Text or Email18
- Alarm Output19
Default Menu Structure Listing20
Advanced Programming28
Control Strategy28
- Growth Cycle28
- Enable/Disable Growth Curve28
- Set Duration of Entire Grow Cycle28
- Vegetative/Flowering Duration28
- Set Vegetative and Flowering Start Weeks28
- Set Start Date for Entire Cycle28
- Change Setpoints and Settings of Weeks And/Or Phases28
- To Save Entire Schedule for Future Use28
- To Restore Schedule for Use29
Advanced Timing Control29
- Setting a Third Time Setpoint in a 24Hr Period (DIF)29
- Once Daily or Single Event Overrides29
Advanced Lighting Control29
- Working with an Independent Light Timer29
- Separate Light Bank Enable29
- Power Cool down Time30
Advanced Temperature Controls30
- Temperature Stages30
- Programming Additional Temperature Stages30
- Stage Separation/Width31
- Changing the Stage Separation31
- Deadbands31
- Changing the Temperature Deadband31
- Ramping32
- Setting a Ramp Time between Time Setpoints32
- Air Exchange/Air Dump32
Advanced CO Control32
- Switching between Tank and Generator32
- CO 2 Tank Cycle Settings Set On/Off Time32
- CO 2 Deadband32
Fan Cut32
- To Disable or Re-Enable Fan Cut33
Light Sensor33
- Enable CO Shutoff in Low Light33
- Change Light Threshold and Deadband for CO33
Fuzzy Logic33
- Shutoff in Low Light33
- Enabling and Creating Your Fuzzy Logic Settings33
- Setting Your Fuzzy Logic Cycle Period33
CO 2 Night Setpoint34
- Enabling CO Night Setpoint34
- Changing CO Night Target Once Enabled34

Related product manuals

Preview: Link4 iGrow 1800

Link4 iGrow 1800