EtherFast
®
10/100 LAN Cards
7
Windows 98 Installation &
Setup
Overview
After physically installing the EtherFast 10/100 LAN Card in your computer,
follow these instructions to install the network driver. The installation proce-
dure for the network driver will vary slightly depending on which version of
Windows 98 you are using, and on your current system configuration. If at
any time during the installation you encounter problems, consult the
Troubleshooting section on page 45.
Installing the Network Card’s Driver
1. If you haven’t already, start up your computer.
2. Windows 98 will automatically detect the presence of the PCI Ethernet
Controller hardware in your computer.
3. Slide the EtherFast Card Driver Disk into your floppy drive while the Add
New Hardware Wizard window is visible. Click Next.
To Next Page
Loading...
