Linksys E1200 - After Saving Settings

Field Electronics Setup Guide FTC_FIELD
Rev 10 1/23/2013 9 ©2012 FIRST Tech Challenge
2.3. After saving settings:
2.3.1. Open Start > Programs > Accessories and select “Command window.”
At the prompt, type:
Ipconfig /release <press enter> : The following screen should appear showing your IP address 0.0.0.0: (It may take
a minute)
Ipconfig /renew <press enter> The following screen should appear showing your that your IP address is in the
192.168.2.1xx range (Note: it may take a minute for the command to complete).
Close the command window by clicking on the X in the upper right corner.
Default setting
Change this to a 2