7
The light in the top corner
of the router should start
flashing blue.
Once the light turns solid
purple, the router will begin
to configure itself. This will
take up to 5 minutes.
Now go to step 8.
6
Connect the power cable to the ‘Gigaclear
powered by Linksys’ router and turn the device
on. The power switch is on the underside.
Now go to step 7.
SPNMX42 SPNMX55
Switch on
8
Once the router has finished
configuring itself and is
connected to the internet,
the light will turn solid
blue. (If the router does
not configure itself, you can
initiate the setup by either
using the Linksys app and
following the instructions, or
by pressing the RESET buon
5 times in quick succession).
Once the LED is solid blue
(may take 5 minutes) the
router is online and you can
connect your devices using
the WiFi details shown on the
label underneath the device.
Now go to step 9.
Open the Linksys App and create an account.
Once the account has been created, log in and
add the router to your account. The app will
take you through the set-up process.
When prompted for a local administration password,
enter the password found on the boom of the
router, followed immediately by the recovery key.
Congratulations, you are now connected
to full fibre broadband!
Optional
Search for and download the
‘Linksys App’ to your mobile device.
9
Reset
To Next Page
Loading...
