Linksys PAP2 Manual Configuration
Copyright © 1999-2006 Go2Call.com, Inc. and/or its suppliers. All rights reserved. “Go2Call” and all associated logos are trademarks, registered as applicable, of Go2Call.com, Inc., and may not be reproduced without Go2Call’s permission. Other product
and company names herein may be the trademarks of their owners. This document is provided “as-is” by Go2Call.com, Inc. for the user’s internal and non-commercial use. Go2Call.com, Inc. does not promise that the information herein is accurate or
complete and all use of such information is solely at the user’s risk. All warranties disclaimed.
page 7 of 7
OPTION 5: Basic Inbound/Outbound Configuration with Go2Call DID. Please note that this is an older Inbound/Outbound
configuration that does not include calling features.
SIP Port 5065
Proxy sipproxy.go2call.com
Outbound Proxy sipnt.go2call.com:5070
Register yes
Make Calls without Reg: no
Use Outbound Proxy: yes
Use Outbound Proxy in Dialog: yes
Display Name Type Your Name
User ID Type in Go2Call DID
Password Type in DID Password
Use Auth ID yes
Auth ID Type in Go2Call DID
Preffered Codec G729a (or G723 if you want to use two ports simultaneously)
Dial Plan Leave the factory default value. Do not touch this field.
STEP 4 Continued from page 3
D. If you want to configure “Line 2” repeat one of the above configurations with a new Go2Call DID/PIN account.
E.
After you have filled in the values of Line 1 (and Line 2), click “Save Settings.”
F. Close your browser. The Linksys adaptor that you have received for phone service is now fully configured to work with
Go2Call service. You are ready to make calls!
To Previous Page
Loading...
