1-866-736-1303 yak.ca
Over 10 years of Canadian Customer Service
ii. Press **** (in other words, press the star key four times). Wait until you hear the “Linksys
configuration menu – please enter the option followed by the pound (#) key or hang up to exit”
response.
iii. Press 130# and listen to the IP address being read out. Enter the IP address in your web
browser to access the ATA.
iv. Press # (pound) key. To exit the menu, hang up the telephone.
2. Open a browser. Enter the ATA IP address, and click the GO button or hit ENTER.
3. Click on the Wan Setup tab.
4. Change the connection type from DHCP to PPPOE.
5. Enter your DSL user name is the PPPOE Login Name field and your DSL password into the PPPOE Login
Password field
6. Click “Submit All Changes” at the bottom of the screen.
7. Once the changes have been accepted, reboot all your devices or power off and proceed to verify internet
connectivity.
Internet Connection Settings
Static IP Settings
Status
Wan Setup
Lan Setup Application
PPPoE Settings
Router
Voice
User Login basic | advanced
Connection Type:
Static IP:
Gateway:
PPPOE Login Name:
PPPOE Service Name:
DHCP
NetMask:
PPPOE Login Password:
Installation Guide For
The Linksys SPA2102
To Previous Page
Loading...
