Wi-Fi Protected Setup™ is a feature that makes it easy to set up your wireless network. If your wireless
router or access point supports Wi-Fi Protected Setup, then you can use Wi-Fi Protected Setup to
connect this device to your router or access point. Otherwise, use manual setup (refer to
“Manual Setup” ).
There are two methods available for Wi-Fi Protected Setup.
1. Use Wi-Fi Protected Setup Button
- Click or press the Wi-Fi Protected Setup button on the wireless router.
- Within two minutes, click the Wi‑Fi Protected Setup button on this device’s Wi-Fi Protected Setup
screen.
- After WAP300N has been configured, click Close.
2. Enter Wi-Fi Protected Setup PIN from WAP300N on the Router
- On the router’s Wi-Fi Protected Setup screen, enter the PIN number listed on WAP300N’s Wi-Fi
Protected Setup screen. Then click Register or the appropriate button on the router’s Wi-Fi Protected
Setup screen. (The PIN number is also listed on the label on the bottom of WAP300N.)
- On WAP300N’s Wi-Fi Protected Setup screen, click OK.
- After WAP300N has been configured, click Close.
Regardless which method was used, the Wi-Fi Protected Setup Status, Wireless Band, Network Name
(SSID), and Security mode are displayed at the bottom of the screen.
Manual Setup
On this screen, you manually enter the information of your wireless network to connect this device to
your network. Alternatively, you may use Wireless > Wireless Network Site Survey screen to establish
the wireless connection (recommended). To establish the connection using Wireless > Wireless
Network Site Survey screen.
To Next Page
Loading...
