Linksys WRT610N V1 - User Manual

Thank you for purchasing the 6dBi Antenna Mod Kit for your Linksys router. First we will show you how
to install the antennas for your router. Next we will provide you with a tool that will help test the
performance of your newly modified router.
WRT610N V1 Antenna Installation Instructions:
1. No soldering required
2. Open the unit. You can use a torque wrench (size T10) or the sharp end of a kitchen knife will
work(we don’t recommend this).
3. Remove the UFL antenna connectors. (If you use both 2.4 ghz and 5 ghz remove top one of each)

Summary

WRT610 N V1 Antenna Installation

Router Disassembly and Initial Cable Handling

Steps to open the router, and handle UFL connectors and cables.

UFL Connector Practice and Port Identification

Practice fitting new UFL connectors and identifying TX/RX ports for antenna connection.

Physical Modifications for Antennas

Drilling Preparation and Marking

Steps to detach existing cables, remove the board, and mark the unit for drilling.

Drilling Execution and Final Assembly

Guidance on drilling, cleaning, attaching new cables, RP-SMA plugs, and 6dBi antennas.

Performance Testing with WIFI Radar Scanner

Using WIFI Radar Scanner for Signal Analysis

Instructions on using WIFI Radar Scanner to test signal strength before and after modification.

Linksys WRT610N V1 Specifications