• If you have a Wireless-N (802.11n) 2.4 GHz-only network, this mode adds support for the 5 GHz
radio band.
• If your current wireless router has a limited wireless coverage and you have a wired network in your
house, this mode can extends the wireless coverage, by creating an additional wireless network, if
you connect this device to your wired network.
Access Point mode is the default operation mode in case the device is being reset to factory default
settings.
If you would like to use WAP300N in this mode,
Step 1: Proceed to Setup > Operation Mode and follow the instructions to set the device to this mode.
Step 2: Proceed to Wireless > Basic Wireless Settings and follow the instructions to configure the basic
wireless settings.
Step 3: Proceed to Wireless > Wireless Security and follow the instructions to configure the wireless
security.
Step 4: Use an Ethernet cable to connect WAP300N’s Ethernet port to the Ethernet/LAN port of your
existing router or your wired network.
Wireless Media Connector Mode
In this mode, WAP300N adds wireless networking capability to any wired (Ethernet-capable) device (e.g.
game console, media player, DVR, smart TV or network access storage). If you have a wired network
device, connect it to this device for wireless network access.
If you would like to use WAP300N in this mode,
Step 1: Proceed to Setup > Operation Mode and follow the instructions to set the device to this mode.
Step 2: Proceed to Wireless > Wireless Network Site Survey (recommended) or Wireless > Basic
Wireless Settings , and follow the instructions to configure the basic wireless settings.
To Next Page
Loading...
