With multiple WAP300Ns operating in this mode, WAP300Ns can wirelessly connect two or more wired
networks together.
NOTE: When this device is set to Wireless Bridge mode, it will communicate only with other WAP300N(s)
that is/are also in Wireless Bridge mode. Therefore, you will need at least two WAP300Ns to make use
of this operation mode.
If you would like to use WAP300N in this mode,
Step 1: Proceed to Setup > Operation Mode and follow the instructions to set the device to this mode.
Step 2: Proceed to Wireless > Basic Wireless Settings and follow the instructions to configure the basic
wireless settings.
Step 3: Proceed to Wireless > Wireless Security and follow the instructions to configure the wireless
security.
Step 4: Connect WAP300N’s Ethernet port to one of your wired networks. Repeat step 1 to 3 on
additional WAP300Ns and install one WAP300N in each wired network that needs to be wirelessly
connected together.
To Next Page
Loading...
